The reason why the glass lined reactor is not automatically filled with water

If the glass lined reactor is too dirty, there will be no water, but after eliminating this cause, what else can cause this failure? In order for everyone to use it better, we need to understand and take a look.

　　 Reason: There must be a certain amount of air in the glass lined reactor. There is too little air in it. The pressure switch cannot be turned off when the pump is working. At the same time, there is no pressure in the water in the pressure tank, no pressure in the output pipe, and no water when the tap is opened. Only when the pump is working. It is equivalent to the water pump adding pressure to the water supply pipeline, and it is not that the pressure tank adds pressure to the pipeline, and the water output is only when the water nozzle is opened.

　　Measure: Open the air release valve above. If not, turn on the pressure gauge or pressure switch above to release some water.

　　 If the water spout can't discharge water, discharge the sewage from the bottom valve, discharge part of it, and then power on and test the water.

　　 The efficiency of the glass lined reactor will be greatly reduced if it is not filled with water, so we should take correct measures to solve it in time after understanding the reason. This also requires users to learn more about the knowledge of the glass lined reactor in case of emergency.